Uncategorized

This Set up makes ends bulletproof.  easy to master because of the ability to position the wheel up and down. […]

Modern EOD Robotics (where it all started) (toycen.ca) These were Pretty cool , we were doing network video before real

  In this post we are going to show how to regrind variable pitch Endmills. Regardless of the endmill Variable

We were presented with a bit of a challenge — A couple of 10 mm ball endmills, not sure of

  The above pictures and Movie  Step drill created on a Journeyman JXT ================================================================== Next, we have a Step drill

Created in the early 1970s  the 16.75-inch long spindle tube is not as useful as it once was and I

Even though there are similarities with the old Cm03 Cuttermaster Attachment This is completely different, wider dovetails , machined from

Ends Overview JXT FLute grinding set up overview

When you come across a large tool that needs a new end this is a good way to take the

Flutes are easy, making good center cutting ends is not so easy, until now. With the new JXT its any