ER32 Manual Shank Grinding attachment for Neck Reduction grinds, tool cut off, perfect Weldon set screw flats fits on all Cuttermaster Models
THE DC MOTOR,BEING VARIABLE SPEED MAKES THIS GRINDER MORE USEFUL. DO NOT OVERLOAD THE MOTOR AT LOWER […]
Make your HTD30 or FCG 30m CM01,JXT or CM01P a surface grinder
Just remove the center bolt in the middle , (in the t slot groove) Install the lever
Cuttermasters This Week IMTS 2024 Booth Number 237058
If you would like tickets to the show, send us an email IMTS 2024 Booth Number 237058 Stop in
Uncategorized
Keen Knife edge 2000 grit Abrasive Machined VS 2000 grit Honed result
Abrasive wheel 2000 Same edge
End Mill Sharpening
Recall: Tool Grinder (CM-01 and JX) Handwheel Scale Rings
Some tool grinders shipped during 2023 have 90 increments per revolution marked on the hand wheels instead of 100. If
Uncategorized
Bladesman DC 2024 1X42
Neoprene Stroping belt coming up 🙂 Blade thinning Coming up , Platen Surface
Uncategorized
Large Shell Reamer 2.1875 Inch Resize and Create pilot
In this video we resize a shell reamer a few thousandths , and grind a non cutting pilot; At 2.187
Uncategorized
Neck Reduction Grinds
I had this nice new Long 4 Flute to Radius grind and neck. Was fun (interesting set up on the
Uncategorized
Setup tips for secondary angle grinds on larger Bull nose Rads on a JXT or a CM01P
Use the bar height stop to time the horizontal flute. Use Step pin indexing pin Tilt the tool into the step
Uncategorized
Carbide T-Cutter Top and Bottom radius and neck reduction grind
In this Video we grind small corner rads on a carbide T cutter I definitely would not have tried this